Operator's Manual
First Edition • Second Printing
Inspections
38
Z-60/37DC • Z-60/37FE
Part No. 1270491
Test the Oscillating Axle (if equipped)
86
Drive the right steer tire up onto a 15 cm block
or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
87
Drive the left steer tire up onto a 15 cm block
or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
88
Drive both steer tires up onto a 15 cm block or
curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test Emergency Controls
89
Push in the red Emergency Stop button to the
off position.
90
Pull out the red Emergency Stop button to the
on position.
91
Press down the foot switch.
92
Simultaneously move and hold the emergency
power switch and activate each function
control handle, toggle switch or thumb rocker
switch. Note: To conserve battery power, test
each function through a partial cycle.
Result: All boom and steer functions should
operate.Drive functions should not operate
with emergency power.
Test the Lift/Drive Select Function
(if equipped)
93
Press down the foot switch.
94
Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate.
The machine will move in the direction
indicated on the control panel.
Repair any malfunctions before operating the
machine.
Test Aircraft Protection Package
(if equipped)
Note: Two people may be required to perform this
test.
95
Extend the primary boom approximately
30 cm.
96
Move the yellow bumper at the bottom of the
platform 10 cm in any direction.
97
Activate each function control handle or toggle
switch.
Result: No boom and steer functions should
operate.
98
Move and hold the aircraft
protection override switch.
99
Activate each function control handle or toggle
switch.
Result: All boom and steer functions should
operate.
