Operator's Manual
First Edition • First Printing
Inspections
36 Z
®
-45 XC
™
Part No. 1301594GT
56
Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
57
Drive the machine onto a slope where the
chassis pitch angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
58
Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
59
With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 4.5°.
Result: The machine should continue to drive.
60
Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
61
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
62
Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
63
Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
64
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
65
Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
66
Return to level ground and stow the boom.
67
With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
68
Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
69
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
70
Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
Test the Oscillating Axle
71
Drive the right steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
72
Drive the left steer tire up onto a 6 in/15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
73
Drive both steer tires up onto a 6 in/15 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
