Terex Genie SX-135 XC, Service And Repair Manual, Page: 56 / 258

Service and Repair Manual October 2016
Repair Procedures
46 SX-135 XC Part No. 1263382
17 Attach a lifting strap from an overhead crane
to the barrel end of the jib boom extension
cylinder.
18 Remove the pin retaining fasteners from the
jib boom extension cylinder barrel-end pivot
pin. Use a soft metal drift to remove the pin.
19 Carefully slide the jib boom extension cylinder
out of the jib boom and place it on a structure
capable of supporting it.
Crushing hazard. The jib boom
extension cylinder could become
unbalanced and fall when
removed from the jib boom if not
properly supported.
Note: During removal, the overhead crane strap
will need to be adjusted for proper balancing.
3-5
How to Remove the Jib Boom
Bellcrank
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Remove the platform. Refer to Repair
Procedure, How to Remove the Platform.
2 Remove the platform mounting weldment and
the platform rotator. Refer to Repair
Procedure, How to Remove the Platform
Rotator
.
3 Remove the jib boom. Refer to Repair
Procedure, How to Remove the Jib Boom.
4 Attach a lifting strap from an overhead crane
to the jib boom bellcrank.
5 Remove the jib angle sensor.
6 Remove the pin retaining fastener from the
bellcrank lower link pivot pin.