Terex Genie SX-135 XC, Service And Repair Manual, Page: 32 / 258

Service and Repair Manual October 2016
Platform Controls
22 SX-135 XC Part No. 1263382
1-2
Joysticks
How to Calibrate a Joystick
The joystick controllers on this machine utilize
digital Hall Effect technology for proportional
control. If a joystick controller is disconnected or
replaced, it must be calibrated before that
particular machine function will operate.
Note: The joystick must be calibrated before the
threshold, max-out or ramping can be set.
Note: After each joystick is calibrated, check the
display at the ground control box. There should be
no calibration faults shown on the display. If
calibration faults exist, repeat procedure for that
joystick controlled function.
Note: Perform this procedure with the engine off.
Note: Use the following chart to identify the
description of each LCD screen control button
used in this procedure.
Plus Minus Previous Enter
Drive functions:
1 Turn the key switch to the off position.
2 Press and hold the
enter button on the
ground control panel while turning the key
switch to platform controls. Hold the enter
button for approximately 5 seconds.
3 Press the minus button twice, then press the
enter button twice.
4 Use the scroll button to scroll through the
menu until DELETE DRIVE JOYSTICK
DEFAULTS is displayed.
5 Press the plus button to select YES, then
press the enter button.
6 Do not start the engine.
7 Locate the drive/steer joystick.
8 Move the drive/steer joystick full stroke in the
forward direction and hold for 5 seconds, then
return to the center or neutral position.
9 Move the drive/steer joystick full stroke in the
reverse direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls
should sound for a successful calibration.