Terex Genie SX-135 XC, Service And Repair Manual

Page: 46 / 258

Service and Repair Manual October 2016
Platform Components
36 SX-135 XC Part No. 1263382
5 Turn the key switch to ground controls.
6 Open the ground control box.
7 Locate the calibration toggle switch at the top
of the ground control box. Activate calibration
mode by moving the toggle switch in the left
direction.
8 Temporarily install a control box door retaining
fastener between the door and the box to
prevent the control box door from moving the
toggle switch while calibrating the machine.
9 Remove the key from the main key switch.
Insert the key into the bypass/recovery key
switch and turn it to the bypass position.
Note: The platform overload calibration values will
not be saved correctly unless the key switch is in
the bypass position and the calibration toggle
switch is activated.
10 Press and hold the
enter button on the
ground control panel while pulling out the
ground controls red Emergency Stop button to
the on position. Hold the enter button for
approximately 5 seconds and then release it.
11 Enter sensor calibration mode by pressing the
buttons at the ground controls in the following
sequence: (plus)(enter)(enter)(plus) .
12 Press the enter or previous button on the LCD
screen until DELETE LOAD CELL FACTORY
CALIBRATION is displayed.
13 Press the plus button to select YES, then
press the enter button to accept.
14 Press the enter or previous button on the LCD
screen until CALIBRATE LOAD CELL ZERO
is displayed.
15 Press the plus button to select YES, then
press the enter button to accept.
16 Add weight to the platform corresponding to
the rated capacity of the machine, determined
in step 3. Place the weight near the center
entry point of the platform, farthest away from
the rotator as possible.
Note: The calibration weight may be ±5% of the
rated capacity. It is advisable that it be slightly less
than the rated capacity.
17 Press the enter or previous button on the LCD
screen until LOAD CELL FULL LOAD LBS or
LOAD CELL FULL LOAD KGS is displayed.
Press the plus or minus button to adjust the
display to indicate the actual weight.
18 Press the
enter
button to accept.
19 Press the enter or previous button on the
LCD screen until EXIT is displayed.
20 Press the
plus
button to select YES, then
press the enter button to accept.
21 Turn the key back to the run position and
remove the key from the bypass/recovery key
switch. Insert the key into the main key switch.
22 Wait approximately 20 seconds and turn the
machine off by pressing the red Emergency
Stop button in.
23 Remove the fastener that was temporarily
installed. Close the control box door and
install the door retaining fasteners.
24 Note: When the control box door is closed, the
calibration toggle switch is automatically
activated to exit out of calibration mode.
25 Pull out the red Emergency Stop button.