Terex Genie GS-3369BE, Operator'S Manual

Page: 32 / 58

Operator's Manual
Third Edition • First Printing
Inspections
30 GS
™
-
2669BE • GS
™
-
3369BE • GS
™
-4069BE Part No. 1305656GT
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
46 Fully lower the platform.
47 Place a 2x4 or similar piece of wood under both
wheels on one side and drive the machine up
onto them.
48 Raise the platform approximately 7 ft / 2.13 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
49 Press the drive function button.
50 Press and hold the function enable switch on
the control handle.
51 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
52 Lower the platform and remove both pieces of
wood.
Test Elevated Drive Speed
53 Raise the platform approximately 8 ft / 2.4 m
from the ground.
54 Press the drive function button.
55 Press and hold the function enable switch on
the control handle. Slowly move the control
handle to full drive position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.44 ft / 13 cm per second.
If the drive speed with the platform raised exceeds
0.44 ft / 13 cm per second, immediately tag and
remove the machine from service.