Operator's Manual
Second Edition • First Printing
Work Area Safety
10
Genie Lift
™
Part No. 1314200GT
Do not operate the machine unless the wheel / leg
/ caster configuration is properly installed.
Prior to use, check the work area for drop-offs,
holes, bumps, debris, unstable or slippery surfaces
or other possible hazardous conditions.
Avoid debris and uneven surfaces while rolling a
machine without the legs installed.
Do not replace machine parts critical to stability or
structure with items of different weight or
specification.
Do not cause a horizontal force or side load to
machine by raising or lowering a fixed or
overhanging load.
Do not use the machine on a moving or mobile
surface or vehicle.
Fall Hazards
Do not use as a personnel
lifting platform or step.
Do not stand or sit on the
forks, load platform or
boom.
Do not climb on the
machine.
Collision Hazards
Do not raise if the load is not properly centered on
the forks or load platform.
Check the work area for
overhead obstructions or
other possible hazards.
Do not stand under or
allow personnel under the
machine when the load is
raised.
Do not lower the load unless the area below is
clear of personnel and obstructions.
Use common sense and planning when
transporting the machine on an incline, slope or
stairs.
Maintain proper lubrication on the frame channels.
See the Pre-operation Inspection section.
Unlubricated frame channels can bind or stop
moving, which could result in the load shifting or
falling.
Bodily Injury Hazard
Do not grasp the cable.
Keep hands and fingers away from the pulleys,
carriage and other potential pinch points.
Do not place arms, hands or fingers through the
frame.
