Rev A
Instructions
Procedure
Part No. 1295343GT
ALC-600 Software Update
7
Model Configuration and Region
Settings
1 Turn the key switch to ground controls.
2 Press and hold buttons
2
and
3
. Pull out the
red Emergency Stop button to the on position.
3 You will be prompted for a password.
Enter
3 - 3 - 2 - 4
.
4 Press the
Settings
button to access the
settings menu.
Note: There will be a delay while the menu is being
loaded on the display screen.
5 Select
Model Configuration
. Press
OK
.
6 Confirm
Models
,
Tires
and
Engine
are set
correctly for your machine.
7 Select
Region
. Press
OK
.
8 Select the appropriate region for your
machine. Press
OK
.
Note: The region options are
ANSI/CSA
,
AUS
and
CE
.
9 Press
Escape
/
Escape
.
10 Cycle the red Emergency Stop button off, then
back on.
Result: No faults are displayed. Continue with
step 11.
Result:
A Model Configuration Fault
(116-31)
is displayed, continue to
How to
Recover from a Model Configuration Fault
.
11 Perform function test. Refer to the Operator's
Manual located on your machine.
12 Return the machine to service.
How to Recover from a Model
Configuration Fault
Note: Only perform this procedure if a
Model Configuration Fault was still displayed
after the Model Configuration and Region
Settings was completed.
Note: When performing this procedure, certain
machine calibration procedures from the
Service and Repair Manual that is appropriate
for your machine will be required.
1 Turn the key switch to ground controls.
2 Press and hold buttons
2
and
3
. Pull out the
red Emergency Stop button to the on position.
3 You will be prompted for a password.
Enter
3 - 3 - 2 - 4
.
4 Press the
Settings
button to access the
settings menu.
Note: There will be a delay while the menu is being
loaded on the display screen.
5 Read and record the
Options
and
Speeds
settings on the document included with these
instructions.
Note: The settings must be recorded before
proceeding.
6 Select
Restore Defaults
. Press
OK
.
7 Select
Reset Models and Options
. Press
OK
. Follow the prompts displayed on the
screen.
8 Press and hold buttons
2
and
3
. Pull out the
red Emergency Stop button to the on position.
9 You will be prompted for a password.
Enter
3 - 3 - 2 - 4
.
