Terex AL4L, Service Manual

Page: 23 / 67

REV B
Section 3 • Scheduled Maintenance Procedures August 2016
Part No. 229171 AL4L • AL5L 3 - 9
A-10
Perform Engine Maintenance -
Kubota D1105-D3BG Models
Engine specifi cations require that this procedure
be performed every 100 hours or quarterly,
whichever comes fi rst.
• Fuel lines and clamps
Required maintenance procedures and additional
engine information is available in the
Kubota
D1105 Operators Manual (Kubota part number
16622-89166)
Kubota D1105 Operators Manual
Genie part number 131379
5 Visually inspect the winch cable for the
following:
• nicks (partial strand cut through)
• kinks in the cable (permanent bends)
• weld spatter
Result: Nicks, kinks in the cable or weld spatter
are found. The cable must immediately be
replaced.
6 Visually inspect the winch cable for the
following:
· crushed spot on the cable
Result: A crushed spot on the cable measuring
125% of the cable diameter or more is found
OR there is a broken wire at the crush point.
The cable must immediately be replaced.
7 Wind the cable onto the winch, ensuring that
the cable is correctly installed onto each of the
pulleys.
CHECKLIST A PROCEDURES