GLW760 IP User Manual XM1586-V1.1-NR
34
11.
ERROR MESSAGES
When you turn on the device
，
it will first perform a reset
.
The display may show
“
Err channel is
XX
”
should there be problems with one or more functions
.“
XX
”
stands for channel 1
，
2
，
3
，
4
，
5
，
6 etc whose sensor has encountered a problem
.
For example
，
when the display shows
“
Err
channel is Pan movement
”
，
it means there is an error on channel 5
.
If there are errors on channel
1
，
channel 3
，
channel 8 at the same time
，
you may see the error message
，
“
Err channel is Pan
movement
”
，
“
Err channel is Tilt movement
”
，
“
Err channel is Shutter
”
，
flash twice
，
and then the
device will generate a second reset
.
If the error messages persist after performing a reset more
than twice
，
the channels which have errors may not work properly however
，
all other functions
can work as usual. Please contact your dealer or manufacturer for service
.
Self repair is not
allowed
.
PAN- movement Er
(PAN- yoke movement error) This message will appear after the reset of the fixture if the yoke’s
magnetic-indexing circuit malfunction (Optical Sensor or Magnetic Sensor fails) or the stepper
motor is defective (or its driving IC on the main PCB)
.
The PAN-
movement is not located in the
default position after the reset
.
TILT- movement Er
(TILT- head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions ((Optical Sensor or Magnetic Sensor fails)) or the stepper
motor is defective (or its driving IC on the main PCB)
.
The TILT-
movement is not located in the
default position after the reset
.
Zoom wheel Er
(Zoom wheel- error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepper motor is
defective (or its driving IC on the main PCB)
.
The Zoom - movement is not located in the default
position after the reset
.
12.
CLEANING AND MAINTENANCE
The following points have to be considered during inspection
：
1) All screws for installing the devices or parts of the device have to be tightly connected and
must not be corroded
.
2) There must not be any deformations to the housing, lenses, rigging and installation points
(ceiling, suspension, trussing)
.
3) Motorized parts must not show any signs of wear and must move smoothly without issue
.
4) The power supply cables must not show any damage, material fatigue or sediment
.
Further instructions depending on the installation location and usage have to be adhered to by a
qualified installer and any safety concerns have to be removed
.
