DE10-Nano
Getting Started Guide
July 25, 2017
www.terasic.com.tw
25
Chapter 6
Running Web Server on the
DE10-Nano
6.1 Introduction
Chapter 6 describes how to run the web server on the DE10-Nano. Users can connect the
DE10-Nano to a computer via the micro USB cable and interact with the board through the website.
The website will guide you through the steps of learning about the board from evaluation to full
development. Next, we will describe how to run it on Windows OS as below. (In section 6.2, we will
have detail descriptions on how to run the DE10-Nano on Window OS.)
6.2 Hardware Setup and Driver Install
1.
Make sure the Factory MircoSD card is inserted into the MircoSD card socket on the board and
the MSEL[4:0] switch is set to “01010”.
2.
Use the Micro USB cable to connect the USB connector on the DE10-Nano board to a USB port
on a computer. Once they are connected, plug in the 5-volt power adapter to power up the board.
