Teradyne Z1800 Series, Operator'S Manual

Page: 16 / 118

1-5
Z1800-Series Operator’s Guide
Warning Terminology
The following terms are used in respect to Teradyne products.
Power On/Off
Sequence
The steps below describe how to turn the power on and off under normal operating
conditions.
Important:
For emergency situations, see the “Emergency Off Procedures” section.
The Power Control switch is on:
•
Operator control panel for the following testers:
Z1890
Z1888
Z1884
Z1880
Z1860
Z1860-NB
Z1850
Z1840
Z1808
Z1805
•
Dual operator control panel for the Z1866
•
Test jack panel for the following testers:
Z1820
Z1800
•
Operator control pod for the following testers:
Z1860M
Z1850M
Z1840M
Power On
Follow the steps below to turn the power on to the tester and other accessories. See Chapter
3 of your tester-specific system reference for information about powering up the tester after
installation or maintenance.
1
Turn on the Power Control switch.
Turn on the switch at least 30 minutes prior to production use to ensure that the
analog components of the stimulus and measurement instrumentation have reached
temperature equalization.
2
Turn on the computer.
Z1866: Turn on the computers for systems A and B. Refer to your computer manual
for more information.
3
Turn on the printer.
Term Definition
Danger HAZARD PRESENT. Before proceeding, refer to the operator or maintenance
documentation to avoid personal injury and damage to equipment, or HAZARD NOT
IMMEDIATE, but potentially lethal if a barrier is removed.
Caution POTENTIAL HAZARD. Before proceeding, refer to operator or maintenance manual to
avoid personal injury and damage to equipment.
Warning WARNING. Calls attention to a hazard. If the procedure, practice, or condition is not
adhered to or is performed incorrectly, injury or death could result.