Teradyne Z1800 Series, Operator'S Manual

Page: 102 / 118

3-9
Z1800-Series Operator’s Guide
no next step, pressing the Start key when repeating the last measurement of a
component turns Repeat off.
The Repeat button does not function with shorts or ignores.
•
Cathode Ray Tube (CRT)
When CRT is on, program progress information is displayed on the CRT. One line of
information is displayed per test step. The information shows the test ID, test name, and
description.
The test ID describes the component, for example, R14. The test name is the component
type, for example, 10K resistor, 7404. The description includes any other pertinent
information.
• Status Display
When Status Display is on, the Status Line at the bottom of the screen shows the
measured values, node, pin, and whether that test step passed or failed.
Running the Test Program
Running the test program requires you to select the test program and execute it. You can
select any permitted command from within a menu by
•
Clicking the menu name with the mouse
• Typing the highlighted or key letter
•
Using the arrow keys to navigate through the menu then pressing the Enter key to
invoke the function
Important:
For the Z1866, you must choose whether the two systems are to work independently or in
parallel. Choose Independent or Tandem on the operator control panel.
Files Edit Run Pgen Setup Utility Templates GFI Convert
C:\TPD\DEMO.DCA-ICT
High: 5.0000 Measure: 0.1221 mV Node: 249 Pin: 1 PASS
START CANCEL SOF HLD RPT CRT
CRT
Begin
cir_flgs
Caps Discharge 5mv
Testing in progress...