TCW112-CM-R3.2 - March 2018
Page 6
7.3
Network Setup page
The Network parameters are set on this page. The following parameters can be changed:
Static/DHCP
– IP Address can be static or dynamic (DHCP server should be present in
the network);
IP address, Subnet mask, Default gateway
–
these fields are active if IP address is static;
DNS
– this field is mandatory if domain names are used instead of IP addresses. By
default DNS has the same IP address as Default gateway;
Time Server
and
Time Zone
– these fields are used when e-mail is sent;
Host Name
– up to 16 symbols, it appears as a “Subject” in sent e-mails;
MAC
– device MAC address.
The good practice is to change the default IP address of controller immediately after first power-
on. This will avoid collisions if many devices are used on the same network. It may be necessary
to clear the arp cache, each time you connect a new device to the network. This is done by typing
arp -d
in the command prompt window of the computer.
To use e-mail alerts following fields should be completed:
Mail server type
– either “custom” or “tcw gateway”.
“Custom” – public or private mail server without SSL should be used.
Important! TCW112-CM
does not support Secure Socket Layer (SSL);
“Tcw gateway” - dedicated mail server is used.
Important!
The service is free and not guaranteed.
Mail server [IP:port]
– domain or IP address and port of SMTP mail server
;
Sender E-mail
–
sender e-mail;
Username
and
Password
– authentication details for mail server;
Recipient e-mail
.
Summary of Contents for TCW112-CM
Page 1: ......
Page 20: ...TCW112 CM R3 2 March 2018 Page 19 Appendix A Fig 1 Fig 2...
