Tennsmith LM1010-2x, Maintenance Manual, Page: 6 / 41

5
SAFETY INSTRUCTIONS
1. Do not operate service or perform maintenance prior to reading and
understanding the instruction manual. Become familiar with and understand
the hazards and limitations of your shear.
2. Wear approved eye protection and protective footwear while operating the
machine.
3. Be certain this machine is properly wired and grounded to conform to the
National Electric Code. The connection of this machine to the power source
should only be made by and inspected by a qualified electrician.
4. Keep hands and body parts clear of the hold down, cutter head and blade
area.
5. Do not exceed the rated capacity of the machine.
6. Never leave the machine in a power on condition when unattended.
7. Always disconnect the machine from the power source before attempting
maintenance, repairs or adjustments.
8.
DANGER:
Do not attempt to remove the hold down before inserting and
bottoming out the hold down compression bolts (71). The compression bolts
were shipped with the machine. When receiving the shear the bolts are
located inside of the electrical box. Please remove them and store them in a
location to be accessible.
9. Do not remove guards unless required to service the machine. Replace all
protective covers prior to operation.
10. Always wear gloves to protect your hands when handling the shear blades.