Tennant 8400D, Operator'S Manual

Page: 61 / 96

MAINTENANCE
59
8400D MM312 (4–96)
No. of
Lubricant/ Service
Interval Key Description Procedure Fluid Points
100 Hours 1 Radiator Clean core exterior – 1
Check coolant level WG 1
2 Engine belt Check tension – 1
9 Hopper dust filter Check for damage, clean – 1
or replace
3 Hydraulic fluid reservoir Check fluid level HYDO 1
8 Tires Check for damage – 3
11 Main brush and hopper Check for damage or wear – 8
seals
16 Rear squeegee Check leveling – 1
200 Hours 1 Radiator hoses and clamps Check for tightness and wear – 2
14 Parking brake Check adjustment – 1
14 Brake pedal Check and adjust travel – 1
17 Rear wheel support bearings Lubricate SPL 1
10 Side brush guard Rotate 90 – 1
7 Lift arm pivots Lubricate SPL 4
9 Hopper door pivots Lubricate SPL 2
400 Hours 8 Front wheel bearings Check, lubricate, and adjust SPL 2
2 Fuel filter Replace cartridge – 1
15 Fuel tank Remove sediment – 1
1 Cooling system Flush WG 1
800 Hours 3 Hydraulic reservoir Replace filler cap – 1
Replace suction strainer – 1
Change hydraulic fluid HYDO 1
3 Hydraulic fluid filter Change filter element – 1
– Hydraulic hoses Check for wear and damage – All
17 Propelling motor Torque shaft nut – 1
17 Rear wheel Torque wheel nuts – 1
13 Battery Clean and tighten battery cable – 1
connections
Check electrolyte
DW 1
LUBRICANT/FLUID
EO
Engine oil, SAE–CC/CD rated . . . .
HYDO Tennant Company or approved hydraulic fluid .
WG Water and permanent-type ethylene glycol anti-freeze, –34 C (–30 F) . . .
SPL Special lubricant, Lubriplate EMB grease (TENNANT part no. 01433–1) . . .
DW Distilled water . . . .
NOTE: Also check procedures indicted ( ) after the first 50-hours of operation.
NOTE: More frequent intervals may be required in extremely dusty conditions.