MAINTENANCE
8400D MM312 (2–94)
80
SQUEEGEE BLADES
REAR SQUEEGEE
The rear squeegee has two squeegee blades.
Each blade has four wiping edges. To use them
all, start with one wiping edge. To use the next
wiping edge, rotate the blade end-for-end. To use
the next wiping edge, rotate the top edges down,
bottom edges up. To use the last edge, rotate the
blade end-for-end.
Replace any worn or damaged squeegee blades.
REPLACING OR ROTATING REAR SQUEEGEE
BLADES
1. Make sure the squeegee is raised off the
floor.
2. Shut the engine off and set the parking
brake.
FOR SAFETY: Before leaving or
servicing machine; stop on level
surface, set parking brake, turn off
machine and remove key.
3. Remove the ringed pin, deflector, gasket,
retainer bracket, and retainer strip from the
end of the squeegee.
4. Pull the squeegee blade off the squeegee
frame.
5. Replace or rotate the squeegee blade to
allow a new edge to face the front of the
machine.
6. Slide the squeegee blade onto the squeegee
frame
NOTE: Lubricating the squeegee frame where
the squeegee blade makes contact with it will
make it easier to slide the blade onto the frame.
05943
04370
