Tennant 8010, Operator'S Manual

Page: 63 / 106

MAINTENANCE
61
8010 330100 (3--99)
Interval Key Description Procedure
Lubricant/
Fluid
No. of
Service
Points
100 Hours 4 Tires Check for damage -- 3
14 Propelling gearbox Check lubricant level GL 1
14 Front wheel support Lubricate SPL 2
bearing
6 Scrub head parallel Lubricate SPL 8(4)
arm pivot points
14 Steering universal joint Lubricate SPL 2
18 Hopper lift arms Lubricate SPL 2
15 Rear squeegee caster Lubricate SPL 1
11 Brakes Check adjustment -- 1
20 Hydraulic fluid Check level and condition -- 1
500 Hours
13 Scrubbing vacuum fan
motor
Check motor brushes -- 1
12 Steering gear chains
H
Check tension and lubricate GL 2
14 Front wheel H Torque wheel nuts -- 1
6 Scrub head gas spring Check for wear and operation -- 1
800 Hours
20 Hydraulic fluid reservoir
cap Replace -- 1
20 Hydraulic fluid Drain and replace HYDO 1
20 Hydraulic hoses Inspect -- 2
1000 14 Propelling gearbox
H Change gear lubricant GL 1
Hours
H
Change fill-level plug seals -- 1
9 Scrubbing brush drive Check motor brushes -- 2(3)
motors
4 Sweeping vacuum fan
motor
Check motor brushes -- 1
14 Propelling motor Check motor brushes -- 1
19 Side brush motor(s) Check motor brushes -- 1
12 Sweeping brush drive
motors
Check motor brushes -- 1
SPL -- Special lubricant, Lubriplate EMB grease (Tennant part no. 01433--1)
GL -- SAE 90 weight gear lubricant
HYDO -- Tennant or approved hydraulic fluid
NOTE: Also check procedures indicated (
H
) after the first 50-hours of operation.