Tennant 255 Series II, Operator'S Manual, Page: 54 / 128

OPERATION
255 SERIES II MM189 (12---89)
2-32
TO REMOVE SNOW BROOM ASSEMBLY
1. Drive the machine to the snow broom storage
area.
2. Stop the engine and set the machine parking
brake.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, set parking brake,
and turn off machine.
3. Lower the snow broom.
4. Disconnect the hoses from the
quick-disconnect station. Replace the coupling
caps.
5. Reconnect the hose from the machine to the
operator-side port of the quick-disconnect
station to reengage the main brush motor.
A
B
02755
RECONNECTED HOSE
A. Operator-Side Port
B. Hydraulic Hose
6. Disconnect the two limiting chains from the
machine frame.
A
B
C
02759
LIMITING CHAIN
A. Pin
B. Hook
C. Limiting Chain
7. Remove the upper ends of the mounting frame
from the lift arm cams.
8. Tilt the lift arm hooks back away from the lift
arm pins.
9. Push the lift arms down to clear the lift arm
pins.
10. Start the engine, release the parking brake,
and back the machine away from the snow
broom assembly.