Tennant 255 Series II, Operator'S Manual, Page: 51 / 128

OPERATION
2-29
255 SERIES II MM189 (12---89)
TO REMOVE SNOW BLADE
1. Drive the machine to the snow blade storage
area.
2. Stop the engine and set the machine parking
brake.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, set parking brake,
and turn off machine.
3. Lower the snow blade.
4. Disconnect the two limiting chains from the
machine frame.
5. Remove the upper ends of the mounting frame
from the lift arm cams.
6. Tilt the lift arm hooks back away from the lift
arm pins.
A
B
02759
LIFT ARM HOOK
A. Pin
B. Hook
7. Push the lift arms down to clear the lift arm
pins.
8. Start the engine, release the parking brake,
and back the machine away from the snow
blade assembly.
SNOW BROOM
The snow broom accessory gives the machine the
added flexibility to remove snow from walks and
driveways. It consists of two groups of parts --- the
mounting frame, and the broom frame and drive
assembly. The mounting frame is used to mount
either the snow blade or snow broom assembly on
the machine. The broom frame and drive assembly
may be positioned so as to sweep snow to the left or
right of the machine. Check the snow broom for
tangled string or wire after each use.
TO INSTALL SNOW BROOM ASSEMBLY
1. Remove hopper as described in TO REMOVE
HOPPER WITH DOLLY
.
2. Raise and chain up the front bumper, if present,
and the side brush arm.
3. Position the broom mounting frame lift pins in
the lift arm slots. Push the lift arm hooks over
the pins.
A
B
C
D
02759
LIFT ARM HOOK
A. Pin
B. Hook
C. Mounting Frame
D. Limiting Chain