EN
MAIN/SIDE BRUSH SELF-ADJUSTMENT
FEATURE:
The system allows the brush to immediately and constantly follow all
types of surfaces, self adjust to surfaces and self adjust for main/side
brush wear through out the life of the brushes.
The brushes must be replaced when the code “FS0” appears on the
display.
ADJUSTING THE SIDE BRUSH:
To adjust the side brush, remove the top cover, and turn adjusting handle
in the direction required.
REMOVING THE BATTERY:
WARNING: Installation and connection / removal of the batteries
must be carried out by an TENNANT-approved technician (hereinaf-
ter referred to as qualified personnel).
WARNING: the battery is a sealed unit and guaranteed safe under
normal conditions; in the unlikely event of fluid leaking from the
battery, do not touch the fluid and be sure to take the following pre
-
cautions:
► Contact with the skin can cause irritation; wash with soap and
water.
► Inhalation of vapours can cause irritation to the airways; stay out
in the open air and consult a doctor.
► Contact with the eyes can cause irritation; flood the eyes with
water immediately and thoroughly for at least 15 minutes, and
consult a doctor.
When removing the batteries, the operator must be equipped with
suitable personal protection devices (gloves, goggles, overalls, safety
shoes, etc.) to reduce the risk of injury. Make sure the switches on the
control panel are in the “0” position (off) and the machine is turned off.
Keep away from naked flames, do not short circuit the battery poles, do
not cause sparks and do not smoke. Proceed as follows:
► disconnect the battery cables from the battery poles.
► if necessary, remove the devices fixing the battery to the base
of the machine.
► lift the batteries from the compartment using suitable lifting
equipment.
11
