Snappi System User Manual
Document No: 053-05 v38
Page 52 of 76
June 2022
Snappi System User Manual.doc
•
If you are fitting a rain cover as well as the frame padding, it is important that you fit
the rain cover to the pushchair first and then fit the frame padding round it. Finally
join the rear flap of material to the sides of the rain cover with the Hook & loop tabs.
•
6.6: Frame Padding
Fig 6.5.1
To fit the frame padding, simply wrap
around the section of framework to be
padded, and clip the snap fasteners
together (See Fig 6.6.1). Repeat on the
other side.
If you are fitting a rain cover as well as the
frame padding, it is important that you fit the
rain cover to the pushchair first and then fit
the frame padding round it. Finally join the
rear flap of material to the sides of the rain
cover with the Hook & loop tabs.
6.7: Grip Rail
– not suitable for rearward facing Snappi
The grip rail is provided with two
thumbscrews for fitting to the pushchair (See
Fig 6.7.1).
Important:
The grip rail is not designed as a
safety barrier. Suitable harnessing must
always be used.
Fig 6.7.1
To fit the grip rail, place the vertical tubes
into the receivers on either side of the seat
unit (See Fig 6.7.2).
Note there may be a small plastic cap in the
top of the receiver. If this is the case,
remove the cap using a small flat bladed
screwdriver before fitting the grip rail.
Once you have the vertical tubes in place,
put the thumb screw in the hole on the back
of the receiver and tighten until the tube is
being held securely
– do not over-tighten.
Fig 6.7.2
