Breeze User Manual
6
Mounting Bolts
Each Enclosure must be mounted with FOUR points.
All mountings must be made using the four M8
threaded holes on the bottom of the enclosure.
Use a 5mm hex key to secure the M8 socket cap
screws provided.
If the screws provided are not long enough to reach
through your structure, use any stainless steel M8-
1.25mm screw of sufficient length.
Tempest Lighting recommends the use of stainless
steel mounting hardware.
Make sure the inlet filter has at least 75mm/3in
clearance below.
IMPORTANT SAFETY NOTICES
Installer must ensure that all mounting points are secure
and conform to local safety regulations. Tempest Lighting
Inc. accepts no responsibility for damage or injury arising
from inappropriate or unsafe installation.
Hanging a Breeze Enclosure
If you need to hang your Breeze enclosure – for example
below a ceiling or soffit, use the four hanging adapter
plates supplied, along with M12 or ½” threaded drop
rods, as shown here:
5mm
Hanging adapter Plates
(included)
Drop rods (not included)