Breeze User Manual
3
Introduction
Thank you for purchasing a Tempest enclosure! We have worked hard to provide you with the very best
product available for its purpose, and we shall continue to do everything possible to ensure that it works
well for you for many years to come.
Please read this manual before starting work!
In the event of difficulty, please contact your Tempest reseller or Tempest direct:
+1 818 787 8984
We will do everything we can to help you get the very best results from your Tempest enclosure.
IMPORTANT: Safety Advisories
All installation and rigging work done must where applicable be designed and built in accordance
with norms and standards of the local authority having jurisdiction of the installation site. It is the
responsibility of the installer to obtain such approvals as may be required to achieve full
compliance.
All electrical work must be carried out by a suitably licensed electrical contractor in full
compliance with local electrical standards.
Lifting: some enclosures and the equipment inside them may be heavy. Use properly rated lifting
equipment where appropriate and never attempt to carry out work with fewer than the number
of workers needed to lift safely.
It is the responsibility of the installer to ensure that all local building, safety and electrical codes
are strictly adhered to in the installation of this enclosure. Tempest Lighting, Inc., its employees
and agents are in no way responsible for damage arising from failure to follow either the
instructions in this manual or building, safety and electrical codes prevailing at the installation
location.
Do not attempt to install or operate the enclosure before fully reading and understanding this
manual
Never allow anyone who has not read this manual to open the enclosure or perform maintenance
on the projector within.
Never leave the enclosure unattended when open.
Always make sure all bolts and latches are tight and safety locks are in place after performing any
form of maintenance on the unit.
Do not open any electrical boxes until power has been shut off to all supply lines to the enclosure
(including the one powering the projector).
Do not open the enclosure in wet weather.
