TEMA TELECOMUNICAZIONI
AD630VoIP SIP 25W / PoE Horn
MAS-AD630-REV01EN
Page 23 of 46
•
Microphone volume: Sets the microphone sensitivity and consequently the volume of the audio to the user
within the company. Possible values range from 0 (very low) to 9 (very strong).
•
Input for Push-to-talk: with a value different of 0 (for example 1 if you wish to use input 1), the doorphone
will use the indicated input to activate the microphone (Push-to-talk). When the call is connected, the
remote end cannot hear the audio from microphone, unless the button is locally pressed (and it should be
pressed all the time you desire to talk).
•
Local Ringer volume: sets the volume of the ringer issued by the system for incoming calls. Possible values
range from 0 (mute ringer) to 9 (very strong).
•
Multicast audio streaming volume: if you want to use the system to play on its speaker the received
Multicast streaming (voice announcements), it is possible to decide the volume level. In this way it is
possible to differentiate the level of the volume of a normal call and the level of an announcement.
•
Tone signalling: it is possible to give to the external warning tones (press button, call, end call).
•
Tone volume: sets the volume of any warning tones emitted. Possible values range from 0 (very low) to 9
(very strong).
•
Echo limiter threshold: this parameter is used to configure the audio level for switching the conversation
between caller and called. The default value is optimal for normal communication environments.
•
Amplifier in communication: it must be checked, activates the amplifier function.
•
Keyboard/Button panel: set the type of expansion, keyboard or button panel.
9.6. Set of the operating mode
In the operating mode, it is possible to set the mode to DAY / NIGHT / INTERVAL, either manually or automatically
(following time slots per week). This page is also configured to change the codes to the remote phone and
coordinates the installation (used to relay Twilight mode 2):
•
Current mode: allows to set the current mode of operation.
•
Change mode codes: enter the codes to change mode remotely (from any internal phone, call the horn
and, at the answer, via DTMF type the code corresponding to the selected mode). The codes must consist
of 2 characters.
•
Time bands: in the case of automatic operation, it is possible to enter up to 5 bands per day. If a field is left
blank, it is unused and the previous corresponding band will be used.
•
Time zone: time zone of the location where the installation is made (+1 for Italy)
•
Latitude/Longitude: Geographical decimal coordinates relative to the installation site. Can be retrieved
easily from the internet (eg. www.mapcoordinates.net/en)
The time zone and the geographical coordinates are needed in the case of activation of relay 2 in "Twilight" mode.