www.telular.com
Telular SX7P
11
3. Charging the Battery
The SX7P phone is equipped with a rechargeable sealed Ni-MH battery.
New batteries are shipped partially charged and should be cycled for best
performance. “Cycling” is fully discharging and then fully charging the
battery to obtain full capacity.
1.To fully discharge the battery, turn the phone on without connecting AC
power and use until “Low Battery” is indicated in the display.
2.Connect AC power, Refer to Page 15, section 6. Connect the SX7P to
AC Power for instructions on connecting power.
3.Charge battery for at least 24 hours before using SX7P on battery
power the fi rst time. The battery icon will fl ash while battery is charging.
4.The power supply can stay connected to the phone after charging has
completed. The phone will recharge the battery when necessary.
The display will show “Full Charge” and the battery icon will stop fl ashing
when charging has completed.
Note:
If you experience frequent power outages, a recharge cycle can be
interrupted leaving the battery in a state of partial charge. It is recom-
mended to follow steps above to restore the optimum performance of the
battery if this should occur.
Getting started
