Auto-Routing Setup (GSM to Extension)
The SX5 can be configured to automatically route an incoming call from the GSM network to an
extension in the PBX when in Extension Mode. Two steps are required to set this up after you
connect a DTMF telephone to the trunk side of the SX5 (marked with a telephone icon).
1. Enable auto-routing by pressing:
#
*
109
*
0 #
2. Configure the extension to route to by pressing:
#
*
110
*
<extension number> #
NOTE:
The extension number can be up to 8 digits, between 0 through 9.
Example: Assume that the SX5 is connected to extension 123 of your PBX. To enable the SX5
to automatically route all its GSM calls to another extension that goes to a specific person or
operator at extension 999, follow these instructions.
1. Make sure you are in Extension Mode by entering
#
*
108
*
1 #
from a DTMF phone con-
nected to the trunk side connector.
2. Enable Auto-Routing by pressing
#
*
109
*
0 #
from the same DTMF phone connected to
the trunk side connector.
3. Configure the auto-route extension (in this example, 999) by pressing
#
*
110
*
999 #
.
4. When the SX5 receives a call, it will automatically answer the call, then dial 999 on the exten-
sion line. This means extension 123 is calling 999.
5. The far end caller (the person who called the SX5) will hear the line answered, then will hear
whatever the PBX presents when calling an extension.
Two-Stage Extension Side Dialing (Extension to GSM)
When connected to a PBX extension, any other extension on the PBX can access the SX5. The
SX5 will always present two-stage dialing where another extension can access the GSM network
(extension side least cost routing). Only Extension Mode setup is required. No other settings
need changing.
Example: The SX5 is connected to extension 123 on the PBX. To allow extension side dialing,
setup the unit for Extension Mode and call the unit.
1. Make sure you are in Extension Mode by entering
#
*
108
*
1 #
from a DTMF phone con-
nected to the trunk side connector.
2. Call extension 123 from another PBX extension (or from the trunk side of the PBX).
3. When called, the SX5 will automatically answer, then present a dial tone.
4. Once a dial tone is heard, you may dial a number. The connection will be over the GSM network.
Phonecell
®
SX5 GSM
24
User Manual
