CALL FUNCTIONS
1
Making Calls
1. Pick up the telephone handset (the phone is now “off-hook”).
2. Listen for dial tone. If service is not available, a No-Service tone is produced. Hang-up the
phone and try again. If the No-Service tone continues, contact your service provider to verify
that cellular service is available.
3. Dial the phone number. The call will be sent automatically.
HINT:
Pressing the Flash key or pressing and releasing the switch-hook after dialing a num-
ber will send the call immediately.
Receiving Calls
When the telephone rings, pick up the handset and begin talking.
Ending Calls
Hang-up the phone (place the handset back onto the telephone cradle).
In-Call Features
Place a Call on Hold
2, 3
To place a call on hold, press the
Flash
key on your phone. If your phone does not have a
Flash
key, press and release the
Switch-Hook
. When the call is on hold, the Hook Indicator LED
will flash and you will hear a dial tone on your phone. If you hang-up your phone when a call is
on hold, the call will be disconnected.
Retrieve a Call on Hold
Press the Flash key or press and release the switch-hook to go back to your held call.
Make a New Call with a Call on Hold (Two-Line Calling)
2, 3
If you want to make another call when the first call is placed on hold, dial the number when you
hear a dial tone after the call has been placed on hold. See
Place a Call on Hold
above. You
cannot go back and forth between calls. If you hang-up the phone all calls will be disconnected.
Answer Call Waiting
2, 3
When you're on an active call, you will hear a beep tone on your phone when a new call is
incoming. To answer the new call and place the first call on hold, press
Flash
or press and
release the
Switch-Hook
.
Answer a Call when Dialing or Off Hook with Dial Tone
Sometimes you may receive a call as you are dialing or when your just about to dial a number. If
this happens, you will hear a call waiting tone (beep tone) on your phone. Press
Flash
or press
and release the
Switch-Hook
to answer the call.
Adjust the Volume Level
If the volume level on the phone is too high or too low, adjust the levels using the keypad on the
telephone. The telephone must be in Tone-Dial (DTMF) mode to adjust the levels.
• To Increase Volume press:
#
*
8 #
• To Decrease Volume press:
#
*
3 #
NOTE
: The default setting allows adjustment of the volume three (3) steps from the default in
either direction (Up or Down). The volume setting remains in effect for future calls until changed
manually. When power to the SX5 is cycled (powered OFF/ON), the default mid-range volume
setting will be restored.
1
Not available on Fixed Wireless Modem models
2
Not available on Fixed Wireless PBX Terminal models
3
Call Hold, Call Waiting, and Two-Line Calling are all network dependent features. Contact your service
provider for information on activating these features.
Phonecell
®
SX5 GSM
7
User Manual
