Teltronics SEB NET-PATHm, Installation And Operation Manual

Page: 59 / 64

NET-PATHm Installation and Operation Guide
Page 5-3
7 Gently lift the retaining clip. Use care – too much pressure on the retaining clip
can cause it to break.
8
Carefully remove the battery from the molded housing.
9 Insert the new battery. Be sure that it is properly seated in the housing and the
positive (+) symbol is on top.
10 Reinstall the main board and replace the retaining screws.
11
Attach the cables to NET-PATHm.
12 Apply power to the unit.
13 You may need to reset the time using the Command Line Interface, or by
downloading a new database. See “Useful Command Line Interface Commands”
on page 3-5.
NET-PATHm DC
Power
If you purchased a NET-PATHm with a DC power connection, you must connect the
power cable to a standard DC power source.
To install the NET-PATHm DC power connection
1
Remote the DC power cord from its packaging.
2 Attach the cord to your DC power source.
• Connect the black wire with the white stripe to positive.
• Connect the black wire to negative.
3 Plug the cord’s barrel connector into the electrical receptacle on the back of the
NET-PATHm.
4 The NET-PATHm will boot automatically when you apply power.
USE BLACK WIRE FOR NEGATIVE
USE BLACK WIRE WITH WHITE STRIPE FOR POSITIVE