26
5.2
System settings
System settings 9 configurable parameters:
Sleep settings, where user can choose sleep mode;
Ignition source, where user can choose between power voltage, digital input 1 and
accelerometer ignition sources
Object Motion Detection Settings, where user can configure 3 ways how FMB900
will detect stopped movement, and change its working mode (for working modes,
read section 5.7);
Static navigation settings, where user can turn static navigation on or off;
Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
GNSS source Settings, where user can choose satellite system.
LED indication, where user can turn on or off indication leds.
Table 3 Configuration parameters
Movement Source
Vehicle on Stop mode
Vehicle Moving mode
Ignition
(recommended)
If ignition (DIN1) is logic low
If ignition (DIN1) is logic high
Movement
(movement sensor)
Internal movement sensor does
not detect movement
Internal movement sensor detects
movement
GPS
GPS fix is available and vehicle
speed is lower than 5 km/h
GPS fix is available and vehicle
speed is higher than 5 km/h
While GPS fix is unavailable, Object Motion Detection Settings are
working like in Msensor mode
Static Navigation Mode is a filter, which filters out track jumps when the object is
stationary. If Static navigation filter is disabled, it will apply no changes on GPS data. If Static
navigation filter is enabled, it will filter changes in GPS position if no movement is detected
(depends on Object Motion Detection Settings). It allows filtering GPS jumps when object is
parked (is not moving) and GPS position is still traced.
