34
Y1 – geofence zone
left bottom corner Y coordinate (latitude);
X2 or R – geofence zone upper right corner X coordinate (longitude) or radius of circle
when Circular zone is used (radius in meters);
Y2 – geofence zone upper right corner Y coordinate (latitude);
Figure 24 Geofence configuration
AutoGeofencing settings
AutoGeofence – the last known position after movement = off (“X on Stop Mode”).
If your car’s being taken away – you can be notified. The shape and size of the geofence
zones are parameters. It is possibility to state whether entering in or out of the geofence
triggers an asynchronous message
.
AutoGeofencing option can be configured by following parameters visible in figure 25
below.
Activate – Enable or Disable AutoGeofence functionality.
Activation TMO – Time period before Geofence is activated after vehicle stops.
Priority – Priority of generated event, which will be applied to saved record.
Enter Event – Event generation on Geofence entrance.
Exit Event – Event generation on Geofence exit.
On Both - Event generation on Geofence entrance Or exit
Note that AutoGeofencing does not require entering coordinates, instead it requires GNSS
visibility. If vehicle stopped and activation timeout has passed, an AutoGeofence will be created
around vehicle’s last position with set Radius value. AutoGeofence event generation works the
same as Geofencing mentioned above.
