Telpar, Inc. MTP Series Receipt Thermal Printer User Manual
2011 Telpar, Inc. (Rev.20110809)
Page 11
DOCUMENT PRESENTER OPTION ONLY
– MTP-2283
The Presenter Sensor (location shown below) detects when the leading edge of the paper has entered far
enough into the presenter section to stop the presenter motor from turning and thereby preventing the
paper from being ejected until the printer prints and cuts the document. It also detects if the document
has been successfully ejected (or retracted) from the presenter section after the document has been
printed and cut. To access the Presenter Sensor,
remove the presenter‟s top paper guide first. To do
this, lightly flex back the spring clip on the side of the presenter until the guide‟s tabs are just fully exposed
(shown below). Then lift and remove the guide from the presenter (right picture).
To access the Presenter Sensor on the
MTP-2283, you must remove the
presenter‟s top paper guide first. To do
this, lightly flex back the spring clip on the
side of the presenter until the guide‟s tabs
are just fully exposed (shown above).
Then lift and remove the guide from the
presenter (right picture).