Telpar MTP-1500, User Manual

Page: 25 / 64

Page 25 of 64
commands. Does not
affect the space between
character lines. Underline
does not apply while
reverse video is enabled.
Set left margin GS L +n +m 1D 4C +n
+m
Set the left margin to dot
position m x 256+
n . Must
be received at the start of
a line. Does not apply in
Pase mode. See GS W.
Set print
position to the
beginning of
print line GS T +n 1G 54 +n n=0 (either 00 or 30hex)
sets the print position to
the start of the print line
after deleting data in the
print buffer. n=1 (either 01
or 31hex) sets the print
position to the start of the
print line after printing
data in the print buffer.
Cut command GS V m 1D 56 +m
+n If m = 1 (either 01hex or
31hex) a cut is performed
and the
+n byte must not
be sent. If m is a capital B
(42hex) then paper is fed
for n dot lines and then a
cut is performed.
Set Right
Margin GS W + n
+m
10 57 +n
+m Sets the print width to m x
256 + n relative to the left
margin. Must be received
at the start of a line. See
GS L.
Print raster bit
image GS v 0 +m
+x1 +x2 +y1
+y2 +data 1D 76 30
m x1 x2 y1
y2 data See 4.4.3 - Set Raster Bit
Image Mode
Table 6 General Usage Print Commands