Telpar MTP-1500, User Manual

Page: 21 / 64

Page 21 of 64
Top of Form See 4.3.5 Top of Form Commands page 34
Disabled Parameters will be processed as normal data.
Empty Enabled only when at the beginning of a line.
Ignored Command code and parameters are ignored.
Start line Enabled only when there is no data in the print buffer
Yes Function is enabled.
Table 5 List of Control Codes and Control Sequences Locations
4.3 Control Codes and Control Sequences Definition
4.3.1 General Usage Print Commands
General Usage Print Commands
Name Command
ASCII
Command
(hex)
+n = data
byte[hex]
Description
Tab HT 09 Move the print position to
the next horizontal tab
position. Default is a TAB
position every 8 columns.
See ESC D.
Line feed LF 0A Print data and feed paper.
Default line spacing =
3.75mm. See ESC 2 and
ESC 3
Form feed FF 0C See Top of Forms
Commands.
See Page Mode
Commands.
CR CR 0D If parallel interface is
selected and automatic line
feed is is enabled (Memory
Switch 1-5) then CR is
treated as LF. See LF.
Real-time request to printer DLE ENQ
+n 10 05 +n +n=01hex, Recover from
error and restart printing
from the line where the
error occurred. +n=02hex,
Recover from an error after
clearing the receive and
print buffers.
ESC ESC 1B ESC Sequence Header
FS FS 1C FS Sequence Header.
GS GS 1D GS Sequence Header.
Set right side character spacing ESC (SP)
+n 1B 20 +n Set spacing to the right of
each character to n x 0.125
mm (n x 0.0049”). Doubled
for Double Wide. Does not
affect the Kanji character
set. Set values
independently in Page and
Normal modes.
Set Print mode
ESC ! +n 1B 21 +n Set Print mode. See