Telpar MTP-1500, User Manual

Page: 29 / 64

Page 29 of 64
4.3.5 Top of Form Commands
Top of Form Commands
Name
Command
ASCII
Command
+n = data
byte[hex]
Description
Form feed FF 0C Print if needed then feed paper to
the next Black Mark if the BM
sensor is enabled. See GS ( F, GS
FF, and DSW1 position 1).
Feed to Black
Mark GS FF 1D 0C Feed paper to the next Black Mark
position. Ignored unless enabled by
Dip SW 1 position 1. See GS ( F,
FF) and Dip Switch settings.
Table 10 Top of Form Commands
For additional information black mark sensing, see Section 2.2.2 Black Mark Sensors Load .
4.3.6 Page Mode Commands
Bar Code Commands
Name
Command
ASCII
Command
+n = data
byte[hex]
Description
Form feed FF 0C Print and return to standard mode.
Printed data is cleared from the
data buffer. The printing area set by
ESC W is reset to the default
setting. See ESC FF, ESC L, and
ESC S
CAN CAN 18 Cancel print data in page mode.
See ESC L and ESC W.
Print data in
Page mode ESC FF 1B 0C Prints all buffered data in the
printing area. Printed data is not
cleared from the data buffer. ESC T
and ESC W values are not cleared.
See FF, ESC L, and ESC S.
Set absolute
print position ESC $ +n +m 1B 24 n m In Page mode with the starting
position (See ESC T) set to the top
left corner or the bottom right corner
this is a horizontal position but with
the starting position set to the top
right corner or the bottom left corner
this is a vertical position. See ESC
\, GS $, GS\.
Select Page
mode ESC L 1B 4C Must be received at the start of a
line. Settings of ESC SP, ESC 2,
ESC 3 have independent values in
page mode and standard mode.
ESC V, ESC a, ESC {, GS L, and
GS W while in page mode makes
the settings for standard mode but
have no affect while in page mode.
The printer returns to standard
mode at power on, reset, or ESC @