22
| Section 6
The
LAN Interface
menu sets the following options for the LAN RJ45 on the back panel:
♦
LAN DHCP
– Off or On
♦
LAN IP Address
– Only used when DHCP is off
♦
LAN subnet mask
– Only used when DHCP is off
♦
LAN Gateway IP
– Only used when DHCP is off
♦
LAN DNS Server IP
– Only used when DHCP is off
♦
Activate Settings
– Accepts the above settings and restarts the LAN interface
When changing any Ethernet port settings, even DHCP, you must select the Activate Settings item for the changes to take
effect.
The
Livewire
menu has the following options:
♦
Select LW Input Stream
– This list box shows the available Livewire streams on your network. After
boot-up, it may take a minute before all available streams have been detected. Highlight the list and press
the control knob to browse the streams. Press the knob again to select the highlighted stream as your
Livewire audio input.
♦
LW Output Stream Number
–
Enter 0 to disable Livewire output. Enter a stream number in the range
1 – 32000 to generate a Livewire stream. Once configured, this stream will always be active, regardless of the
chosen audio input.
To actually use the selected Livewire input stream as your audio input, you must also change your audio input device in the
Audio I/O
menu to Livewire.
The
SIP Server
submenu is only used if your organization uses a SIP server to make VoIP calls. Contact your SIP
server administrator for the values to enter in these fields, or leave them blank not to use your own SIP server.
N/ACIP SIP calls may also be made via “direct dial” to the remote codec’s IP address, without involving a SIP server.
♦
Registrar Hostname
(allows entry of alphanumeric text)
♦
Registrar User Name
(allows entry of alphanumeric text)
♦
Registrar Password
(allows entry of alphanumeric text)
♦
Activate Settings
– Accept the above settings and attempt to authenticate with the SIP server
♦
SIP Port
– Set a custom TCP port to use for SIP, leave blank to use the default of 5060.
For more information on setting up and using SIP, see Section 9.2, N/ACIP Session Initiation Protocol.
The
WiFi/WLAN
menu has the following fields:
♦
Browse SSIDs…
– This button brings up a screen displaying all broadcast network IDs detected by the
Z/IP ONE. Selecting an SSID from the list will fill out the
ESSID Network Name
field for you.
♦
ESSID Network Name
– enter this manually if your access point is not set to broadcast its SSID
♦
Encryption Method
– choose the type of encryption used by your Wi-Fi access point. “String” refers to an
alphanumeric password, while “Hexnum” refers to passwords that are limited to hexadecimal characters
(digit values of 0-9 and A-F)
♦
Pwd String/ Hex Number
– the password required by the encryption method
♦
Activate Settings
– accept the above settings and attempt to authenticate with the Wi-Fi hotspot
