12
Signs indicated in columns G1-G6, S1-S4 and C1-C2:
o
?
-
signal processing in progress
o
*
-
signal transmission successful
o
R
-
signal already transfered in other way, therefore signalling is not necessary
o
!
-
signal transmission failed
o
S
-
alarming has been stopped, therefore signalling is not necessary
o
T
-
signalling timeout
If you keep the mouse pointer above any cell of the table, details of the specific event
will be displayed. If you wish to copy this content, hold down CTRL button on
keyboard and the details will remain displayed therefore the content can be selected
and copied as usual.
•
In "
State messages from the module
" field recent messages of the module with
time of occurrence can be traced. Messages can be cleared by pressing "
Clear
message window
" button.
•
GSM signal strength
: exact value of GSM signal strength (and its graphic level
display)
•
Close window:
press to close this window
6.5 Power supply voltage supervision
The module is not able to monitor the power supply voltage itself. If this function is
necessary, the
BVM-12
accessory unit has to be installed optionally that should be
connected to input Z1. In this case input Z1 cannot be used as zone input. If this optional
unit is used the supply voltage monitoring value can be adjusted with a potentiometer on
the unit between 10 – 12VDC. The GPRS Pager3 will generate a signal (according to
how it is specified on input Z1) when value of supply voltage decreases below the
adjusted value.
Conection of
BVM-12
module has to be done as shown in the figure below:
12V 10V
BVM-12
