tell GPRS Pager 3, Installation And User Manual

Page: 9 / 24

9
5.1.3 Server parameter setting details
•
In a few seconds the actual GPRS settings will be downloaded from the module
•
Saved settings can be imported by pressing " Load from file " button or can be
saved by pressing " Save to file " button.
•
Import settings or perform the desired changes
•
Check the following settings:
•
„ General settings ”:
ƒ
Enter new APN name in „ APN1 ” field (e.g.: internet – in case of T-Mobile
service or the name supplied by your GSM service provider)
ƒ
If you want the module to operate only with the SIM card inserted then enter
the card's PIN code in „ PIN ” field and set " FIX SIM "option. In this case when
the module restarts it will register the inserted SIM card's serial number and
will operate only with that specific SIM !
ƒ
If you wish the module to operate with other SIM cards as well then leave the
" PIN " field blank. Do not select " FIX SIM " option and disable PIN code
request on the SIM card to be placed in the module.
•
„ IP Addresses ” :
ƒ
„ Primary Server IP A ” :
•
Enter the IP address of the monitoring station’s internet connection (has
to be a fixed IP address supplied by the internet provider)
•
Select „ APN1 ”
•
Set „ Port ” 3333
ƒ
„ 1. Reserve Server IP ”:
•
Set reserve server IP address 193.28.86.102 (this is the TELL test server
IP address)
•
Select „ APN1 ”
•
Set „ Port ” 3333
•
"Frequency of GPRS test report messages" : the frequency of GPRS test report
messages is adjustable in minutes to test the existance of GPRS connection.
(default setting: 3 min)
•
If you have ensured the set parameters are correct , press „ Write settings into
the module ” button
•
Wait a few seconds to complete the writing procedure
•
In case of programming through internet/GPRS the new settings will become
effective only after pressing " Restart the module " button !
•
When programming is finished disconnect the USB cable if USB connection has
been used. In case of programming through internet/GPRS the window can be
closed.
6 Installer settings
6.1 Setting parameters using USB serial port connection
•
Start „ GPRS Pager3 ” remoter software
•
Power off the module (disconnect from power supply)
•
If you have already connected the module to PC then disconnect the USB cable
•
Press „ Auto detect USB port ” button then connect the module to the PC with USB
cable (or after pressing „ Select serial port manually ” button you can select the
serial port manually).
•
When the program has detected the serial port used by the module (e.g. COM1)
press „ Open serial port ” button to establish connection.
•
Enter module's password (default setting: 1111)
•
Further details about settings can be found in the following chapters