Telmoss
user’s guide
9/42
2004. Telital mobitel d.o.o. All right reserved.
Hardware installation steps
1.
MOUNTING THE ANTENNA
Apply GSM antenna (Figure 1, pos 3) to the SMA connector (Figure 2, pos 1). Make
sure that antenna is fasten enough (turning it few times to right till reach the end of
the thread) in order to ensure good signal reception.
2.
INSERTING THE SIM CARD
Insert the SIM card into the slot as shown on Figure 2, position 2.
NOTE:
•
PIN request must be disabled on applied SIM card. For this purpose use standard
GSM mobile phone and disable this function. For details refer to mobile phone
user’s guide.
•
applied SIM card must have so called Data/fax subscription number activated. This
number is dedicated for incoming data calls. For more information refer to your
network operator.
3.
PLUG-IN THE CABLES
Plug-in coaxial cables (Figure 3, pos 6) from the cameras previously installed and
connect the wires from sensors (see more details in chapter Sensor port )
4.
PLUG-IN POWER SUPLLY
Plug-in the power supply cable to the connector shown on Figure 3, position 5 and
power supply adapter to the mains socket (220V).
5.
WATCH THE LED INDICATORS
If the power supply is connected properly, the boot sequences starts and after ca. 22
seconds Red Power Supply LED indicator (Figure 4, pos 7) will start to flash. This will
last ca. 30-35 seconds. In the mean time all 3 green GSM signal indicators (Figure 4
pos 8) will blink on/off few times, indicating the presence of GSM module.
Approximately 55 seconds after switching on, Red Power Supply LED indicator stops
flashing and must remain switched on permanently.
Those Camera LEDs are turned on, whose connectors are supplied with proper video
signal.
About ten seconds afterwards, the unit should be properly connected to the network
indicating the signal strength on 3 green LEDs. If those LEDs start to flash please wait
for few seconds (10-20). If this continues, it indicates the permanent problem with the
connection.
So, the device is properly installed if:
•
RED Power Supply LED indicator is switched on
Telmoss
user’s guide
10/42
2004. Telital mobitel d.o.o. All right reserved.
•
at least 1 GREEN GSM signal indicator is switched on
•
at least 1 RED Camera indicator is switched on
Now, if all listed steps are performed successfully, parameter set-up has to be done
using one of the client applications.
NOTE
If SIM card has not been inserted before switching on Telmoss device, the
system software will consider ONLY external devices connected to RS232
connector (Figure 3, pos 4) as the communication devices i.e. external
modem, direct cable connection to PC etc. All three GSM signal LEDs will
blink continuously. Communication will be possible only through this port
and no notification SMS will be sent.