JF2 Hardware User Guide
1vv0300985 Rev.4 2013-04-09
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 9 of 40
Mod. 0805 2011-07 Rev.2
1.4.
Document Organization
This document contains the following chapters (sample):
“Chapter 1: “Introduction”
provides a scope for this document, target audience, contact and
support information, and text conventions.
“Chapter 2: “Powering the JF2”
gives an overview about power supply.
“Chapter 3: “Example Implementations”
describes examples on how to implement the JF2.
“Chapter 4: “Updating Firmware”
describes the SW updating procedure for Flash version.
“Chapter 5: “Updating Patch code”
describes how to apply patch code to ROM version.
“Chapter 6: “ROM2.2 Features”
describes the new ROM2.2 features.
“Chapter 7: “Main Serial Interface”
describes the possible serial interfaces of the JF2.
“Chapter 8: “MEMS sensor and EEPROM Interface”
describes the DR I2C interface.
“Chapter 9: “RF Front End Design”
describes in details the characteristics of the Front end.
“Chapter 10: “Reference Design”
gives an overview about the reference design.
“Chapter 11: “Firmware configuration”
describes the configuration settings.
“Chapter 12: “Handling and soldering”
describes packaging and soldering of the module.
“Chapter 13: “PCB layout details”
describes the mechanical design of the module.
“Chapter 14: “Document History”
describes the history of the present product.
1.5.
Text Conventions
Danger – This information MUST be followed or catastrophic equipment failure or bodily
injury may occur.
Caution or Warning – Alerts the user to important points about integrating the module, if
these points are not followed, the module and end user equipment may fail or malfunction.
Tip or Information – Provides advice and suggestions that may be useful when
integrating the module.
All dates are in ISO 8601 format, i.e. YYYY-MM-DD.
1.6.
Related Documents
JF2 Product Description,
JF2 EVK User Guide,
