Assembly And Maintenance Manual for Telink BLE 1x6 Test System 3.2
AN-18071200-E1
25
Ver 1.0.0
3.2
Firmware burning for EVK daughter boards
Generally multiple sets of 1X6 Jig are used in factory. Note that each Site of each
Jig should be burned with firmware before it’s ready for use.
Each Jig has six Sites including Site0~Site5, corresponding to EVK0~EVK5.
In this section, Jig1 Site0 (EVK0) is taken as an example to show how to burn
firmware to EVK daughter board.
First connect the EVK daughter board (e.g. EVK0) with PC via an USB cable, as
shown in Figure 21.
Note: To burn firmware for EVK daughter board, only the target board should be
connected with PC, while other Sites must be disconnected from PC.
Figure 21 Connection chart between EVK daughter board and PC
Then
double
click
the
“EvkMonitor.exe”
under
the
“BLE_System_V3.2_xxx\Script\Monitor” folder.
Click “download” under the menu “Evk” to open the burning interface.
Connect EVK0 with PC via USB cable
EVK0
Telink
for
customer
