Telindus 1031, User And Reference Manual

Page: 245 / 394

Telindus 1031 Router Chapter 10
Reference manual Configuration attributes
235
telindus1031/bridge/bridgeGroup/vlan
Use this attribute to configure some VLAN parameters.
Although the Telindus 1031 Router bridges IEEE 802.1Q tagged frames when connected to a VLAN
aware switch, the Telindus 1031 Router itself can only be managed via IP if some VLAN parameters are
configured.
The
vlan
structure contains the following elements:
If
dotQTagging
is enabled, then the Telindus 1031 Router does not interpret spanning tree frames but just
forwards them. In that case the spanning tree protocol should be disabled on the Telindus 1031 Router.
bridgeForwardDelay
Use this element to set …
• the delay a bridge port applies to move from listen-
ing state to learning state or from learning state to
forwarding state. Refer to
8.5 - The Spanning Tree bridge port states on
page 144 for more information on the possible states of a bridge port.
• the time-out (or ageing) for purging MAC addresses from the bridge cache in
case a topology change is detected.
Element Description
dotQTagging Use this element to enable or disable …
• the 802.1Q tagging of Ethernet frames sent by the
Telindus 1031 Router.
• the recognition of 802.1Q tagged frames received by the Telindus 1031 Router.
vid Use this element to set the ID of the VLAN over which
the Telindus 1031 Router can be managed.
userPriority
Use this element to set the priority used in the 802.1p
part of the 802.1Q header and this for all frames sent
by the Telindus 1031 Router.
Element Description
Default:00000d 00h 00m 15s
Range: 00000d 00h 00m 04s -
00000d 00h 00m 30s
Default:-
Range: structure, see below
Default:disabled
Range: enabled / disabled
Default:1
Range: 1 … 4094
Default:0
Range: 0 … 7