Telindus 1031, User And Reference Manual

Page: 201 / 394

Telindus 1031 Router Chapter 10
Reference manual Configuration attributes
191
telindus1031/g703[ ]/channel[ ]/frameRelay/lmi
Use this attribute to select the Local Management Interface (LMI) protocol
and to fine-tune the LMI operation.
Refer to 6.3.4 - Configuring LMI on page 84 for more information on LMI.
The lmi structure contains the following elements:
Element Description
mode
Use this element to set the Frame Relay mode.
The mode element has the following values:
type Use this element to set the LMI variant. There are sev-
eral standards for the LMI protocol with small varia-
tions between them. Therefore you should configure
the Telindus 1031 Router according to the standard that is used by your service
provider.
The type element has the following values:
pollingInterval Use this element to set the time between successive
Status Enquiry messages.
errorThreshold
Use this element to set the maximum number of unan-
swered Status Enquiry messages that the Telindus
1031 Router will accept before declaring the DLCI
down. Also see the
monitoredEvents
element.
Default:-
Range: structure, see below
Default:auto
Range: enumerated, see below
Value Description
noLmi
No LMI is used.
user
The Telindus 1031 Router is defined as Frame Relay
user. I.e. Frame Relay access device or DTE.
network
The Telindus 1031 Router is defined as Frame Relay
network. I.e. Frame Relay node or DCE.
auto
When you have two Telindus 1031 Routers in your net-
work and they are both set to
auto
, they mutually decide
who will be user or network.
Default:q933-Annex-A
Range: enumerated, see below
Value Description
lmiRev1
Set this value only for compatibility with older equip-
ment.
ansiT1-617-d Set this value for ANSI LMI compliance.
q933-Annex-A
Set this value for ITU-T LMI compliance.
frf1-2
Set this value for FRF 1 & 2 compliance.
Default:00000d 00h 00m 10s
Range: 00000d 00h 00m 05s -
00000d 00h 00m 30s
Default:3
Range: 1 … 10