Manual Copying
Use this procedure to copy cassettes in Manual mode. Manual mode
requires you to rewind cassettes, using the
Rewind
button.
1.
Set up the X-Gen for copying, as described in the procedure
Setting
Up the X-Gen for Copying
on page 8.
2.
Set the
Auto/Manual
switch to
Manual
.
3.
Set the
Side Select
switch as desired. To change to the
AB
position
(both sides of the master will be copied at the same time) or to the A
position (copy one side only), press and hold the
Side Select
switch.
4.
Press the
Copy
button to begin copying.
5.
Monitor the copying process. Copying will stop when a copy
cassette reaches its end. Use the
Stop
and
Rewind
buttons as
needed, to stop copying or to rewind the cassettes to their
beginnings.
6.
After a Copy cycle, check the
Short Tape
indicators for each
Copy
well. A
Short Tape
indicator lighted red means that the copy tape
stopped copying before the master tape reached the end, so the
copy tape in that well might be incomplete or defective.
Automatic Copying
Use this procedure to copy in Automatic mode. In Automatic mode, the
X-Gen rewinds all cassettes to their beginnings both before copying and
after copying.
1.
Set up the X-Gen for copying, as described in the procedure
Setting
Up the X-Gen for Copying
on page 8.
2.
Set the
Auto/Manual
switch to
Auto
.
3.
On each X-Gen module, press and hold the
Side Select
switch to set
the module to the
AB
position. (Both sides of the original will be
copied at the same time.)
10
