X-Gen Channel Descriptions
The tables below show the X-Gen’s channel assignments, monitored by
the Control module’s four Recording Level indicators.
Mono X-Gen Models
Channel 1
Side A of copy positions in
all X-Gen modules
Channel 2
Side B of copy positions in
all X-Gen modules
Stereo X-Gen Models
Channel 1
Left channel of side A
Channel 2
Right channel of side A
Channel 3
Right channel of side B
Channel 4
Left channel of side B
Connecting Your X-Gen Modules
1.
Position your Control and Copy modules in a row, with the Control
module at the far left.
2.
Starting with the Control module:
Connect a cable between one of
the two 20-pin connectors on the back of the Control module and
one 20-pin connector on the back of the first Copy module. (You can
use either connector on a module). To connect a second Copy
module, connect a cable between the first Copy module and the
second Copy module. To connect other Copy modules, connect
each module to the previous Copy module until all modules are
connected.
NOTE:
Refer to the table on page 6 to use a second Control module as a
Copy module and connect the second Control module as if it were a
Copy module, but do not put a cassette in its
Master
well or attempt
to operate the controls of the second Control module. All functions
will now be controlled by the Control module that contains the master
cassette.
3.
Plug a power cord into the universal power cord receptacle on each
module and into an AC wall outlet or power strip.
7
