CAUTION
If you are using high-bias (CrO2) tape for recording on an XL or
Ferrite model of X-Gen, bulk erase each cassette that you place into
a
Copy
well. If you are recording on normal bias cassettes, X-Gen
automatically erases previously recorded material.
5.
If you want the copy from one side of the master cassette only, press
and hold the
Side Select
switch to set it to A. To change back to
automatically copying both sides of the master cassette, toggle
(press and hold) the
Side Select
switch back to AB.
6.
Set the recording levels for each channel, by performing the
following steps.
a.
Set the
Auto/Manual
switch to
Manual
.
b.
Press
Copy
.
c.
Monitor the recording levels for each channel.
d.
For each channel that needs adjustment, rotate its knob as
needed. Adjust each channel to stay as close as possible to the
0 dB indicator. Occasional peaks of +3 are acceptable, but
peaks of +6 produce poor copies. After the adjustment for each
channel is correct, press the knob down, to prevent your setting
from being accidentally disturbed.
e.
Repeat step 6d for each channel.
7.
Press
Stop
and then
Rewind
to rewind all cassettes to their
beginnings. To begin copying, go to one of the following procedures:
Manual Copying
,
Automatic Copying
, or
Special Copying
Applications
.
9
