Telex KP-812, User Manual

Page: 53 / 106

53
KP-812 Keypanels User Manual
Service Menu, Speaker
This menu item allows the user to select the volume level for either the keypanel speaker and
the headset speaker(s). The default level is -30dB and the range goes from 0 - -60dB.
1. Turn the encoder knob until Speaker displays. Tap the encoder knob.
2. Turn the encoder knob to select either Headset or Speaker . Tap the encoder knob.
3. Turn the encoder knob toincrease or decrease the minimum volume level . The
range is -1dB to -60dB or full Mute.
3. Tap the encoder knob to select the volume level .
4. Press the encoder knob for 1 second to exit.
5. Run Service Menu, Save Cfg to store Speaker settings.
Service Menu, Mod Assign
Note : Normally, this is a service adjustment that is required only when replacing a key and
display module. It may also be required if for some reason, the key assignments, as dis-
played in AZedit, appear to be in the wrong position on the keypanel or expansion panel.
The KP-812 keypanel and EKP-816 use Module ID numbers (Mod ID Numbers) to define the
address of each key and display module. See Figure 7.
1. Turn the encoder knob to display Mod Assign .
All modules go into Select module ID. To exit this procedure without making changes,
tap the encoder once.
All of the alphanumeric displays, appear as shown in figure 7. Assign the Mod IDs as shown
in the figure. Repeat the procedure for each module.
Note : You do not need to run Service Menu, Save Cfg after changing Mod assignments.
Figure 7. Module Assignment Example.
Listen
Talk
Listen
Talk
™
EKP-816
Select Module ID 1
↑↑ ↓↓
Change Select
1. Module ID number
is displayed here.
2. Select the correct Module ID
with this button
(see below).
3. Tap here to assign.
Asterisks will briefly display
while the module updates.
ID 1
ID 5
ID 4
(cannot change)
ID 2
Kanji
EKP-816
ID 6
ID 3
ID 7
ID 8