Setup Information
46
To
configure the IP-223 for use
, do the following:
1.
From the links, select
Basic Ethernet Setup
.
The Basic Ethernet Setup window appears
.
2.
In the Unit IP Address field, enter the
IP Address
.
3.
In the Subnet Mask field, enter the
subnet mask address
.
4.
In the Gateway Address field, enter the
gateway address
, if required.
5.
In the Unit Name field, enter a
descriptive name
.
6.
In the Packet Delay before Playback field, enter the
number of packets
of delay for playback
(each packet is 20ms of
audio)
.
7.
In the QOS: Precendence Bits field, enter the
number of bits
, if required.
8.
In the QOS: D, T, and R Bits field, enter the
number of bits
, if required.
9.
In the Local Computer IP Address fields, enter the
IP Addresses
of the IP-223 units that are located in the same
room.
10.
Click
Submit
.
The entries currently displayed on the window are sent to the IP-223 for storage.
11.
From the links, select
Save to EEPROM
.
The Save Setup Parameters window appears
.
12.
Click
Save Parameters
.
The entries are saved to permanent memory.
Submit Button
The
Submit
button, located at the bottom of each configuration window, is used to upload changes to the IP-223.
IMPORTANT:
The submit button saves changes in temporary memory only.
To
permanently save changes,
do the following:
1.
Click
Submit
.
The changes are sent to the IP-223 in temporary storage.
2.
Click
Save to EEPROM
.
The Save to EEPROM window opens
.
3.
Click
Save Parameters
.
Changes are now permanently saved to the IP-223 console
Summary of Contents for IP-223
