Televic TCS5500, Installation Manual

Page: 91 / 125

Appendix A
Installation manual to TCS5500 Appendix A
● 83
be disabled if the corresponding microphone is activated.
A supplementary RJ45 connector must be provided.
1 IHS5500
INT 5500
You can connect up to four IHS5500 units to the INT5500. An IHS
system uses one MIC port and one DCS port with the same
number.
Special configurations
2 Microphones
– 1 loudspeaker
DML 5500
DML 5500
DML 5500
DML 5500
INT 5500
LS 5500
In this configuration there is only one loudspeaker (LS5500) for
two microphones. One loudspeaker is connected to port 1 and the
other to port 3.
When so configured in the operational control suite software, the
microphones connected to MIC port 1 and 2 of the INT5500 will
mute the LS5500 connected to DCS port 1 of the INT5500 when
one of the two microphones is activated. The same is true for the
microphones connected to MIC ports 3 and 4. If they are activated
the LS5500 connected to DCS port 3 will be muted.
Master
– slave microphones
Two microphone panels can share 1 physical microphone. The
following must be taken into account
The master microphone panel must be connected to port number 1
or 3 of the INT5500. This microphone panel must contain the
shared microphone and audio path.