User´s Manual
Audio/Video Transmitter & Receiver
80
Selection of channel and sampling time
Selection of channel in the transmitter
The A/V transmitter sends the audio and video signals through the channel that you
have selected. You can use up to 4 transmitters
(1)
at the same time, taking care that each
transmitter has selected a different channel.
The example shown in the figure illustrates the
A/V signal being transmitted through channel 1.
The A/V receiver lets you select a fixed channel to receive the signal (switches 1 to 4)
or else carry out a sequential sweep of the selected channels. The sampling time that the
receiver applies to each channel can be selected via the switches 5 and 6.
The example shown in the figure illustrates the reception
of the A/V signals through channel 3 (switch 3 in the ON
position).
The example shown in the figure illustrates the sequential
reception of the A/V signal through channels 1 and 3 with a
sampling time of 2 seconds. When more than one channel is
selected, the sampling mode is enabled.
Switches 5 and 6 enable you to select the sampling time between the 4 possible
combinations.
Selection of the receiver’s channel
1 2 3 4
CHANNEL
1 2 3 4 5 6
on
CH
T
1 2 3 4 5 6
on
CH
T
5 6
T
5 6
T
5 6
T
5 6
T
16 sec.
8 sec.
4 sec.
2 sec.
(1) It depends on the model. Do not select two channels with the same frequency.
